Denver Instrument IR-35 Betriebsanleitung Seite 5

!
Clean your moisture analyzer
only according to the cleaning
instructions (see "Care and
Maintenance").
Do not open the analyzer housing.
If the seal is broken, this will result
in forfeiture of all claims under the
manufacturer's warranty.
If you have any problems with your
moisture analyzer:
Contact your local Denver office,
dealer or service center
Warning: Severe Burns!
– When setting up the moisture
analyzer, leave enough space to
prevent heat from building up
and to keep your analyzer from
overheating:
– leave 20 cm (about 8 inches)
around the moisture analyzer
– leave 1 m (3 ft.) above the
moisture analyzer
– Do not place any flammable
substances on, under or near the
moisture analyzer, because the
area around the heating unit will
heat up
– Be careful when removing a sam-
ple from the chamber: the sample,
the heating unit and the sample
pan may still be extremely hot
– Prevent excess heat build-up
around the analyzer
Hazards for persons or equipment
posed by certain sample materials:
Fire
– Flammable or explosive
substances
– Substances that contain solvents
– Substances that release flammable
or explosive gases or vapors
during the drying process
In some cases, it is possible to
operate the moisture analyzer in an
enclosed nitrogen atmosphere to
prevent the vapor released during
drying from coming into contact
with oxygen in the surrounding
atmosphere. Check on a case-to-case
basis whether this method can be
used, because installation of the
analyzer in too small an enclosed
space can affect its functioning (for
instance, through excessive heat
build-up within the analyzer). When
in doubt, perform a risk analysis.
The user shall be liable and respon-
sible for any damage that arises
in connection with this moisture
analyzer.
Explosion
5