Denver Instrument IR-35 Betriebsanleitung Seite 20

Example: setting the following drying parameters
Final temperature: 130
Start of analysis: without stability after the cover is closed
End of analysis: after 10 minutes
Display mode for result: moisture
Step
1. Turn on the analyzer
2. Select PRG: drying
program parameters
3. Confirm PRG
(the previously set
temperature is displayed;
in this example, 105°C)
4. Set the heating
temperature
(in this example: 130°C)
5. Confirm heating
temperature (the
previously set analysis
time is displayed; in
this example, 0.0 min)
6. Set the parameter for the
end of analysis; in this
example, 10 minutes)
7. Confirm the "end of
analysis" parameter
8. Select the result
display mode (in this
example, moisture)
20
C
°
Key (or instruction) Display
e
y
u
x repeatedly
u
x repeatedly
u
x or y
Self-test runs
°
105
C
°
130
C
0.0
min
10
min
%M
l