Connecting The Moisture Analyzer - Denver Instrument Ir-35 Betriebsanleitung

10
Connecting the Moisture Analyzer to AC Power
Check the voltage rating and the plug design
The heating element has been factory-set
to 230 V or 115 volts for technical reasons.
The voltage has been set as specified on
your order. The voltage setting is indicated
on the manufacturer's label (see the back
of the analyzer), for example:
– 230 volts: IR35M-...230..
– 115 volts: IR35M-...115..
!
If the voltage indicated on the label does
not match your local line voltage:
Do not operate your moisture analyzer;
contact your local Denver office or dealer.
Use only
– Original Denver power cords, or
– Power cords approved by a certified
electrician
– If you need to connect an extension cord,
use only a cable with a protective grounding
conductor
Connecting the moisture analyzer, rated to
Class 1, to AC power (mains supply): Plug the
power cord into an electrical outlet (mains sup-
ply) that is properly installed with a protective
grounding conductor (protective earth = PE)
Safety Precautions
If you use an electrical outlet that does not
have a protective grounding conductor, make
sure to have an equivalent protective conduc-
tor installed by a certified electrician as speci-
fied in the applicable regulations for installa-
tion in your country. Make sure the protective
grounding effect is not neutralized by use of an
extension cord that lacks a protective ground-
ing conductor.
Connecting Electronic Peripheral Devices
Make absolutely sure to unplug the analyzer
from AC power before you connect or discon-
nect a peripheral device (printer or PC) to or
from the interface port.