General Characteristics - Cembre HT51-KV Bedienungsanleitung

ENGLISH

1. GENERAL CHARACTERISTICS

TOOL TYPE:
Application range:
Crimping force
Rated operating pressure
Dimensions
Weight
Recommended oil:
Operating speed:
Safety:
2. INSTRUCTIONS FOR USE
2.1) Setting
(Ref. to Figs. 1 and 2)
– Select the appropriate die set for the connector.
– Open the latch (21) and release the upper die holder (22).
– Insert one die into the upper die holder (22) and one die into the lower die support (20).
– Close the latch.
Ensure that the latch (21) and the upper die holder (22) are fully secured, otherwis damage
may occur during tool operation.
– Remove the handle restraint (01) to release the moveable handle (36).
– Insert the conductor into the connector.
– Locate the connector between the dies at the desired crimp position.
2.2) Die advancement
– Operate moveable handle (36) for die advancement. This first stage rapidly closes the dies to the
connector (the automatic opening of the moveable handle allows the operation of the tool using
one hand, while locating the connector in the desired crimp position with the other).
Make sure that dies are exactly positioned on desired crimp point; otherwise, re-open dies fol-
lowing instructions as per § 2.5 and position the connector again.
suitable for installing electrical compression connectors
kN (sh ton):
bar (psi):
mm (inches):
380 x 130 (14.9 x 5.1)
kg (lbs):
AGIP ARNICA 32 or
SHELL TELLUS TX 32
the tool has a twin speed operation and automatically
switches from a rapid advancing speed of the ram
the tool is provided with a maximum pressure valve:
HT51
for conductors up to 240 mm
50 (6)
600 (8,700)
2,75 (6)
or equivalent.
to a slower more powerful crimping speed.
MPC1 gauge is available to check
the correct setting of the valve
HT51-KV
(500 MCM)
2
386 x 130 (15.2 x 5.1)
3,0 (6.6)
AGIP ITE360 or
ESSO TRANSFORMER P60
or equivalent.
4