Operation; Transport Safety Lock; Changing The Cutting Attachments - Silvercrest SHBS 3.7 C2 Bedienungsanleitung

6. Operation

Regardless of the charging state of the battery, the 5-in-1 hair and
beard trimmer can always be mains-operated.
1. For mains operation, ensure that the hair and beard trim-
mer 5 is switched off.
2. Connect the power unit 10 to the connector of the hair and
beard trimmer 5.
3. Insert the power unit 10 into a readily accessible wall socket
whose voltage matches the voltage stated on the rating plate.
4. Switch on the device with the on/off switch 7.

6.1 Transport safety lock

When the transport safety lock is activated, the battery symbol 8
flashes blue 3 times.
• Press and hold the on/off switch 7 for approx. 3 seconds to
activate/deactivate the transport safety lock.
• By connecting the power unit 10, the transport safety lock is
deactivated, and also cannot be activated while plugged in
to the power supply.

6.2 Changing the cutting attachments

WARNING! Risk of injury!
Switch off the hair and beard trimmer 5, before you attach
or remove the attachments.
• Figure A: to remove the attachments 3, 4, 12, 13, 14 use
your thumbs to press the attachment towards the rear of the
hair and beard trimmer 5.
68
GB