Charging; Battery Charger - Silvercrest SHBS 3.7 C2 Bedienungsanleitung

5. Charging

NOTES:
• Before first use (without cable), and for every charging pro-
cedure afterwards, charge the hair and beard trimmer 5 for
approx. 90 minutes.
• When the batteries are almost empty, the plug symbol 9
flashes in red. The device can then only be used for a short
time without being connected to the electricity supply.
1. Place the battery charger 11 on a level surface.
2. Connect the power unit 10 to the battery charger 11.
3. Switch off the device with the on/off switch 7 if necessary.
4. Insert the power unit 10 into a readily accessible wall sock-
et whose voltage matches the voltage stated on the rating
plate.
5. Put the hair and beard trimmer 5 into the battery charg-
er 11.
6. The plug symbol 9 is lit red and the battery is charged.
When the battery is fully charged, the battery symbol 8
flashes in green. When the battery is fully charged, the de-
vice can be used for approximately 60 minutes without be-
ing connected to the power supply.
67
GB