Victron energy Phoenix 12/30 (1+1) Bedienungsanleitung Seite 4

3. Quick user guide
A. Connect the battery charger to the battery or batteries.
B. Connect the battery charger to the wall socket using the AC cable (can be
ordered separately).
All the LEDs light up briefly and once the charger has been activated the
relevant status LEDs light up, depending on the status of the charger.
By default the charger starts up in normal mode and bulk.
C. If required, press the MODE button to select a different charging algorithm
(the battery charger remembers the mode when it is disconnected from the
power supply and/or battery).
After selecting reconditioning, the RECONDITION LED will light up and start
to blink when reconditioning is active.
The battery charger switches to LOW (low power) when the MODE button is
held down for 3 seconds. The LOW LED will then light up and remain lit, and
the maximum output current will be limited to 50% of the rated output power.
LOW mode can be deactivated by holding the MODE button down for
another 3 seconds.
D. The battery will be about 80% charged and ready for use when the
ABSORPTION LED lights up.
E. The battery will be fully charged when the FLOAT (trickle charging) or
STORAGE LED lights up.
F. You can now interrupt the charging at any time by disconnecting the power
supply to the charger.