Victron energy Phoenix 12/30 (1+1) Bedienungsanleitung Seite 10

NORMAL (14.4V): recommended for wet-cell flat-plate lead-antimony batteries
(starter batteries), flat-plate gel and AGM batteries.
HIGH (14.7V): recommended for wet-cell lead-calcium batteries, Optima spiral cell
batteries and Odyssey batteries.
LI-ION (14.2V): recommended for Lithium Iron Phosphate (LiFePo4) batteries.
CUSTOM (Adj.): recommended for any other type of battery other the the above
mentioned if the adjustable voltages are set according to the battery manufacturer
recommendations.
MODE button
Once the battery charger has been connected to the AC power supply, press the
MODE button to select a different charging algorithm if required (the battery charger
remembers the mode after disconnecting the power supply and/or battery).
After selecting reconditioning, the RECONDITION LED will light up and start to blink
when reconditioning is active.
The battery charger switches to LOW (low power) when the MODE button is held
down for 3 seconds. The LOW LED will then remain lit. LOW mode will remain active
until the MODE button is held down for another 3 seconds.
When LOW is active, the output current is limited to max. 50% of the rated output
power.
Intelligent 7-stage charging algorithm for lead acid batteries:
(with optional reconditioning)
1. BULK
Charges the battery using the maximum current until the absorption voltage is
reached. At the end of the bulk phase, the battery will be about 80% charged
and ready for use.
2. ABS - Absorption
Charges the battery using a constant voltage and a decreasing current until it is
fully charged. See the above table for the absorption voltage at room
temperature.
Variable absorption time:
The absorption time is short (at least 30 minutes) if an almost fully charged
battery is connected and increases to 8 hours for a totally discharged battery.
3. RECONDITION
RECONDITION is an option for the NORMAL and HIGH charging programs and