User Interface And Navigation; Details - Hach SC200 Basis-Benutzerhandbuch

Connect the optional digital communication output
The manufacturer supports Modbus RS485, Modbus RS232, Profibus DPV1 and HART
communication protocols. The optional digital output module is installed in the location indicated by
item 4 in Figure 7 on page 13. Refer to the instructions supplied with the network module for more

details.

For information about Modbus registers, go to http://www.de.hach.com or http://www.hach.com and
search Modbus registers or go to any sc200 product page.
Install a Secure Digital (SD) memory card
For instructions on how to install an SD card in the controller, refer to Figure 12. Information on how
to use the SD memory card can be found in the expanded version of this manual.
To remove an SD card, push down on the edge of the card and release, then pull the card up and out
of the slot. After the card is removed, close the slot cover and tighten the cover screws.
Figure 12 SD card installation

User interface and navigation

User interface
The keypad has four menu keys and four directional keys as shown in Figure 13.
22 English