ABB ACH580 Kurzanleitung Seite 8

8 EN – Quick start-up guide
Refer to the motor nameplate for the following nominal value settings of the motor. Enter the values exactly
as shown on the motor nameplate.
Example of a nameplate of an induction (asynchronous) motor:
EN
DE
ES
FI
FR
IT
Check that the motor data is correct. Values are predefined
NL
on the basis of the drive size but you should verify that they
correspond to the motor.
PT
Start with the motor type.
• Go to the edit view of a selected row by pressing
RU
•
Scroll the view with
Motor nominal cos Φ and nominal torque are optional.
SV
Press (Next) to continue.
To change a value in an edit view:
• Use
and
•
Use and
Press (Save) to accept the new setting, or press
(Cancel) to go back to the previous view without making
changes.
This step is optional, and requires rotating the motor. Do not
do this if it could cause any risk, or if the mechanical set-up
does not allow it.
To do the direction test, select Spin the motor and press
(Next).
and .
to move the cursor left and right.
to change the value.