Silvercrest SCM 1500 C3 Bedienungsanleitung Seite 11

NOTE
► You can adjust the browning level of the crêpe using the temperature con-
trol 5 or by varying the cooking time .
► To work out the right amount of batter, add enough batter to the cooking
plate 1 so that it is around 2/3 covered with batter . Make sure that the
batter does not run over the edge of the cooking plate 1 . If necessary,
reduce or increase the amount of batter for your next crêpe .
4) Dip the batter spreader 8 briefly in water .
5) Use the batter spreader 8 to spread the batter evenly over the cooking
plate 1:
Place the batter spreader 8 on the batter without exerting pressure and move it
in a circular pattern from the middle of the cooking plate 1 working outwards
to the edge . The batter should be spread thinly over the cooking plate 1 .
6) After about 45 seconds (depend on the desired degree of browning) turn
the crêpe using the crêpe spatula 9 .
NOTE
► Dip the batter spreader 8 briefly in water after every use . This helps to
spread the batter evenly .
► It is possible that the light ring 6 can change colour from green to red
and back again while cooking . This indicates that the set temperature has
briefly fallen and the appliance is heating up again .
► The specified cooking times are merely guidelines . The cooking time for crêpes
depends on your personal taste . Work out the best time by trial and error .
7) After another 45 seconds, remove the crêpe from the cooking plate 1 using
the crêpe spatula 9 .
To do this, slide the crêpe spatula 9 under the crêpe and lift it gently . Place
the crêpe on a plate .
8) You can now add your favourite toppings to the crêpe .
CAUTION – PROPERTY DAMAGE!
► Do not spread toppings or decorate the crêpe while it is on the cooking
plate 1 .
► Do not cut the crêpe while it is on the cooking plate 1 .
► Do not use any sharp or metallic objects to flip the crêpe or to remove
it from the cooking plate 1 . This will irreparably damage the cooking
plate 1!
9) Proceed with the following crêpes in the same way .
NOTE
► When the appliance is not in use, always remove the plug 2 from the
mains power socket . This is the only way to ensure that the appliance is
current-free .
■ 8
│ GB│IE│NI
SCM 1500 C3