Key Operations - Magnescale LY71 Handbuch

5. Key Operations

Reset key and external reset input
Start key and external start input
ABS/INC display switching key
SETUP key
Preset key
Axis select key, numeric key and
ENT key/ key operation
External preset value call
(preset recall input)
Datum When not using master
point calibration function
key
Axis select key, numeric key and
ENT key operation
Datum When using master
point calibration function
key
Axis select key, numeric key and
ENT key operation
LY71
At power ON
During count Count display
display axis
Error display axis Each axis : INC = 0, ABS = 0, Peak value = 0
At power ON
During count Count display
display axis
Error display axis Operation prohibited
At power ON
During count Count display
display axis
Error display axis Operation prohibited
At power ON
During count display
At power ON
During count display
Valid in preset mode
During count Count display
display axis
Error display axis Operation prohibited
Valid even in other than preset
mode
During count Count display
display axis
Error display axis Operation prohibited
At power ON
During count display
Valid in datum point mode
During count Count display
display axis
Error display axis Operation prohibited
At power ON
During count display
Valid in master setting mode
During count Count display
display axis
Error display axis Operation prohibited
display →
Count display: During restart
operation, INC display
(master calibration OFF) or when
master calibration is ON, display
waits to go past reference point.
After going past reference point,
display changes to count display.
Each axis : INC = 0, ABS = unchanged,
Peak value = 0
However, when master calibration is
ON, display waits to go past reference
point.
Operation prohibited
Restarts peak value calculation for each axis/all
axes.
Operation prohibited
Switches each axis/all axes between ABS and INC
display.
Hold down to access basic settings.
Accesses advanced settings.
Operation prohibited
Preset lamp lights on and preset operation is
enabled (= preset mode).
(Prohibited when datum point lamp or REF lamp is
lit.)
Up to three values can be stored/edited for each
axis.
(Prohibited when datum point lamp or REF lamp is
lit.)
Calls the first preset value for each axis.
Version display
Datum point lamp lights on and datum point
operation is enabled (= datum point mode).
(Prohibited when preset lamp or REF lamp is lit.)
The values for each axis can be stored/edited.
Version display
Datum point lamp lights on and master setting
operation is enabled (= master setting mode).
(Prohibited when preset lamp or REF lamp is lit.)
The values for each axis can be stored/edited.
17
(E)