Magnescale LY71 Handbuch Seite 42

3. Installation and Connection
Screw down firmly.
DC output connector
Clamp the cable to prevent
the connector from pulling
out.
Provide slack as shown to
ensure that force is not being
applied to the connector.
* Terminal block connector wiring
You can use AWG26-20 size wires with this terminal block.
Remove 8 mm of the wire outer sheath, insert the wire all the way into the terminal hole while pressing location
A above the terminal hole with a flatblade precision screwdriver or other fine instrument, and then remove the
screwdriver.
8
(E)
First axis
2
Measuring unit
input
AC adaptor (option)
100 - 240 VAC ±10 % 50/60 Hz
* Get power from the lamp line.
A
See "* Terminal block
connector wiring" below.
Ground wire
(supplied)
Counter unit anchor bolt
M4 × 16, 2 pcs. (supplied)
Note
Connect the supplied ground wire
to ensure that the counter unit is
the same potential as the machine
proper.
Supplied
LY71