Installation - GRAPHITE 59G824 Betriebsanleitung

RIPPING
Ripping is cutting the material to desired width along its whole length.
● Set the ripping fence (13) to appropriate cutting width.
●
Switch the saw on and wait until cutting blade reaches its full rotational speed.
●
Press the material against the ripping fence (
knife (1) (use the push stick when close to cutting blade).
●
Leave the cut material on the work table until the cutting blade stops completely.
Make a try cut after each adjustment to make sure the new setting is correct. When making a cut
stand to the side of the line of cutting.
CUTTING SMALL OBJECTS
● Set the ripping fence (13) to appropriate cutting width.
●
Feed the material with both hands. When getting close to the cutting blade always use the push stick
(included) to move the material or use additional piece of wood to push material being cut against the
ripping fence (13).
●
Always push the cut material to the end of the riving knife (
When cutting short and narrow objects, use the push stick from the beginning.
USE IN MITRE SAW MODE
If the tool has not been used or has been used in table saw mode, use the cutting blade lift/lower
knob to bring the cutting blade to the lowest position.

INSTALLATION

● Remove the cutting blade shield (3).
●
Bring the cutting blade (
●
Remove the ripping fence (
●
Install the cutting blade bottom shield (
●
Pull away the work table rotation locking lever (
clearly hear the work table rotation locking lever (11) snaps in place (fig. M).
●
Loosen the riving knife fixing knob (
(14) is uncovered, so the sleeve protrusions match the guiding grooves.
●
Fasten the riving knife fixing knob (
USING THE SAW ARM (HEAD)
There are two positions of the saw arm, upper and lower. To release the head from locked lower position,
do as follows:
● Press the saw arm lightly and hold.
●
Pull the head locking pin (
●
Turn the head locking pin (
●
Hold the saw arm as it lifts to its upper position.
●
You can lock the saw arm in lower position by following unlock procedure in reverse order after releasing
the movable shield locking lever (42).
VERTICAL CLAMP
Vertical clamp can be installed at either side of the work table and is fully adjustable to size of the object
to be cut.
● Install the vertical clamp (47) in one of the holes in the work table.
●
Tighten the vertical clamp locking knob (
●
Turn the threaded rod to match the vertical clamp (
●
Secure by pressing the vertical clamp locking lever (
13) and move towards cutting blade to the end of the riving
14) to the lowest position with the cutting blade lift/lower knob (5).
13) and the mitre gauge (18).
7).
11) and turn the work table (12) by 180
38) and turn the riving knife (1) to position where the cutting blade
38) to fix in place.
31) away, so its safety bolt slides out of the locking hole.
0
31) by 90 and lock in the position (fig. N).
46).
1).
47) with processed material.
48) (fig. O).
29
0 until you can