Switch Output; Sleep Mode Timeout - Leuze electronic LSIS 122 Kurzanleitung

6.10 Switch Output

Enable NO Switch output after Noread
(serial Command: 118311).
Never Switchoutput (green LED)
after Decoding
(serial Command: 118300)

6.11 Sleep Mode Timeout

This Parameter have influence on the Data Transmission of the LSIS 120.
If the this value is greater-than-or-equal 1 sec, is no serial Data Transmission of Commands
to the LSIS 122 possible. This is only working with the value 0.
The Parameter 'Sleep Mode timeout' has no influence on the data communiction on the LSIS
123.
Sleep Timeout 0 Seconds
(serial Command: 819500).
The setting after 'Recall Defaults' is 1 Second. It is than necessary to activate
i i i i
the Hardwaretrigger when you want sent Commands to the LSIS 122 or you
want work with the Programm MetroSet.
Remark
(*)
Always Switchoutput (green LED)
(serial Command: 118301).
(*)
Sleep Timeout 1 Second
(serial Command: 119510).
Kurzanleitung LSIS 12x-v171e.doc vom 11/03/2010 Seite 30
after Decoding