Inhaltsverzeichnis
Werbung
6 Configuration with Barcode or serial Commands
6.1 Configuration with reading Barcodes
To open or close the configuration mode it is necessary to read the Barcode 'Enter/Exit
Configuration Mode'. The Codeinformation is 999999 for both.
You can disclaim the reading of the Barcode Enter/Exit Configuration Mode,
i i i i
when you not have Multi-Code Configuration.
The Multi-Code Configuration is with marked with a Tilde (~).
Remark
i i i i
The Parameter from the Factory Default is marked with an asterisk (*).
Remark
i i i i
The activation of addtional Barcodetypes and Functions affected the Decoding-/
Readingspeed !
Remark
6.2 Configuration Commands
To do the configuration, you have to send a command to open and to close it.
The Start or End - string ist 999999.
It is the same when you want to programm the device with barcodes. You must read the
Code Enter program mode and at the end Exit programm mode.
With the factory default of the LSIS 122/123 (COM-Port Emulation) you can setup the device
also with ASCII-Strings. You have to use the framing with STX and ETX when you will send
this:
Prefix:
[STX]
Postfix:
[ETX]
The LSIS 120 answer after each command with ACK or NAK (without framing) .
Command OK:
[ACK]
Command Not OK:
[NAK]
6.3 Example EAN13 deactiviate:
Sending:
[STX]999999[ETX]
Recieving: [ACK]
Sending:
[STX]100201[ETX]
Recieving: [ACK]
Sending:
[STX]999999[ETX]
Recieving: [ACK]
1. Enter Configuration
(Necessary when you do a Multi-Code configuration (~),
if not you can disclaim it !)
3. Exit Configuration
(Necessary when you do a Multi-Code configuration (~),
if not you can disclaim it !)
Hex: 02
Keyboard: Alt+002
Hex: 03
Keyboard: Alt+003
Hex: 06
Keyboard: Alt+006
Hex: 15
Keyboard: Alt+021
2. Configurations code (s)
Kurzanleitung LSIS 12x-v171e.doc vom 11/03/2010 Seite 18
Werbung
Inhaltsverzeichnis
