Inhaltsverzeichnis
Werbung
The parameterisation of the LSIS 120 can be done one 3 different ways:
1. Reading Barcodes with the LSIS 120, for this you must triggering the device with the
integrated Triggerbutton or the Switch input on each Barcode/PDF417-Code.
2. Parameterisation with serial Commandos over the RS232-Interface (LSIS122) or the
USB-COM-Port-Emulation (LSIS123).
For this you need a Terminalprogramm (e.g. Hyperterminal; BCL Config Tool,
MetroSet...)
The Command order is:
Enter Configuration Mode
•
One or more serial Parameter
•
Exit Configuration Mode
•
More Information you will find in Chapter 6
3. Parameterisation with the PC-Programms Metro Set 2
Over the serial RS232-Interface or the USB-COM-Port-Emulation.
The Program you will find on our Homepage
i i i i
Link:
http://www.leuze.de/downloads/log/download-02_de.html
Remark
Informations to install and start the Programm Metro Set2, and also chossing the
Industrial Scanners IS 4920 you will find in chapter 7.
Kurzanleitung LSIS 12x-v171e.doc vom 11/03/2010 Seite 5
Werbung
Inhaltsverzeichnis
