The Program Metroset; Configuration With The Program Metroset - Leuze electronic LSIS 122 Kurzanleitung

7 The Program MetroSet

7.1 Configuration with the Program MetroSet

You can also use the Program MetroSet for setup the LSIS 120. The progam you can find on
www.leuze.de.
1. After Installation of the exe-File, you can start the program with the Link in Start or with
the Icon on the Desktop.
2. To use the Configuration of the LSIS
120, you have to choose the IS 4920
under the Imaging Scanners.
3. Click on the + at Imaging Scanners
1
Scanners and then on the IS 4920
4. Click on the
5. It appears the following window:
6. When you start the first time, you have to choice the Interface which you have connected
the LSIS 120. With LSIS 122 is this normaly the COM-Port of the PC's. Please take care
that you use the COM-Port Emulation at the LSIS 123, and the driver is installed and
works, only in this mode you can work with it. Maybe you need Administration rights for
this
7. Choose the right COM-Port of the available Interfaces.
1
Depending on the Program version the IS 4920 can also be on another place in the list.
to load the Parameters.
Kurzanleitung LSIS 12x-v171e.doc vom 11/03/2010 Seite 34