Using Headphones - Silvercrest SBKO 4.0 B1 Bedienungsanleitung Und Sicherheitshinweise

SilverCrest SBKO 4.0 B1
smartphone or media player. Select the device
"SBKO 4.0 B1" from the list of devices which are
found and establish the connection. If you are asked
for a PIN, enter "0000".
When there is an established connection, the LED (7)
flashes blue once briefly about every 10 seconds. As
soon as the device is switched off or is out of range, the
headphones switch to standby mode (not connected)
and the LED (7) flashes orange once briefly every 3
seconds.
If you want to connect another device (smartphone or
media player) to the headphones, you must repeat the
pairing process as described previously.
As soon as the previously connected device comes
within range of the headphones, the connection is
established automatically. You may need to confirm the
connection on your device.

Using headphones

Note the markings on the inside of the earphones (1) to
put on the headphones correctly: R = right, L = left. The
controls and the LED (7) are located on the right side of
the headphones. Carefully slide one of the earphones
(1) into your ear canal. To do so, insert the earphone
(1) into your ear. To make it easier to insert, you can
straighten your ear canal a little by slightly pulling your
ear back and up. Repeat this process with the second
earphone (1).
16 - English