KERN VFB 2T-3 Betriebsanleitung Seite 74

 Loading the system with the load to be added
 Wait for stability display „STABLE", then press
added into a sum memory
 „ACC 1" is displayed for approx. 2 sec., after that the system returns into the
standard weighing mode. Next to the weight display „M+" appears
 Unload the system, the display returns to „0"
 Charge with the second load, wait for the stability display „
 Press
anew, the weight value will also be saved
 „ACC 2" will be displayed, the total weight will be displayed for approx. 2 sec.
before the system changes into the weighing mode.
 Carry out further weighings in the same way. Ensure that the system is unloaded
between the weighing procedures.
 You can repeat this process until the capacity of the weighing system is
exhausted.
Display of the saved weighing data:
 The system must be in zero display („ZERO"-is displayed)
 Press
, number of weighing, followed by the total weight will be displayed for
2 sec.
Delete weighing data:
 When zero is displayed press
total weight will be displayed for 2 sec. During this display press
The data in the summation memory are deleted. The „M+" in the display
disappears.
31
, the weight value will be
, the number of weighings followed by the
S T AB L E
"
again.
VFB-BA-e-1811