Settings (I); Setting The Tear Position; Setting The First Printing Line (Tof) - Dascom Tally T2240 Kurzanleitung

Settings (I)

Settings (I)
Setting the tear
position
Offline Trac.1
Park LF/FF
Adjust Paperway
Menu Char
TOF
Tear
TearAdj=00/72" *
Set Exit
Setting the first
printing line (TOF)
Adjust Paperway
Menu Char
16
If the tear position of the paper is not aligned with the tear edge of the printer, you can adjust it.
Press the Setup
Online
Setup
Press the Adjust
Online
Setup
Press the Tear
Online
Setup
<
Press the or
Online
Confirm the setting by pressing the
Setup
The correction made (a maximum of approx. 2.5 cm [1"] in both directions) will be retained
after printer power-off.
You can use the TOF function to set the position of the topmost printing line individually for
each paper source and each menu.
You should adjust the tear position (see above) before using the TOF function (when using fan-
fold paper).
Press the Setup
Online
Setup
key. The printer changes to Setup mode.
key.
key.
>
key to move the perforation to the appropriate position.
Set key. The printer returns to its initial status.
key. The printer changes to Setup mode.
Quick start-up