Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
en Instruction Manual
en
8
InPro 3300
Non-Glass pH Combination Electrode
Instruction Manual
12.0 mm
0.47"
1. Introduction
METTLER TOLEDO pH sensor type InPro
tenance, autoclavable and pressure-resistant electrode with a
glass-free sensing head and thickened reference electrolyte.
Please read these instructions carefully before putting the elec-
trode into operation, in order to ensure perfect operation. All
wetted parts are made of materials in compliance with the FDA
directives (Food and Drug Administration). We recommend that
the sensor may only be in operation with the original accessories
from METTLER TOLEDO. The sensor may be operated and ser-
viced only by personnel familiar with the unit, and who have read
and understood this instruction manual.
2. Safety remarks
If an electrode is to be cleaned or calibrated using acid or alka-
line solutions, safety goggles and gloves should be worn.
3. Product designation
The markings on the polymer shaft include the following infor-
mation:
METTLER TOLEDO
InPro 3300/120/Pt xxx Designation/shaft length in mm/
Combination pH
pH 0...14
0...80 °C (130 °C)
Order No. 52 xxx xxx
Additionally, the electrode is supplied with a serial number
marked on the connector cap to enable individual identification
of each electrode produced.
4. Installation and preparation for use
1. Do not touch, hold or make any contact with the plug and/or
pins of the electrode. Electrostatic discharge can damage the
chip.
© 02 / 16 Mettler-Toledo GmbH
Printed in Switzerland
InPro 3300 Non-Glass pH Sensor
1)
2)
3)
4)
5)
6)
7)
Electrode/sensor manufacturer
temperature sensor
Type of electrode
pH measurement range
Temperature range for operation/
(sterilization)
Article number for ordering
1: VP connector
2: Pg 13.5 thread
3: Washer PTFE
4: O-ring (Silicone FDA)
5: PEEK (FDA) shaft
6: Ceramic diaphragm
7: ISFET
3300 is a low-main-
®
InPro 3300
52 002 258
Werbung
Inhaltsverzeichnis
