Assembly; Battery Information; Operation - Husqvarna 115iL Bedienungsanweisung

Introduction
WARNING: Read and understand the safety
chapter before you assemble the product.
To assemble the trimmer guard
1. Assemble the trimmer guard. (Fig. 31).
2. Install the bolt through the housing of the trimmer
head and the trimmer guard. (Fig. 32)
3. Tighten the bolt.
To assemble the trimmer head
1. Turn the output shaft until the hole in the drive disc
aligns with the hole in the gear housing.
2. Install the locking pin in the hole to lock the shaft.
3. Turn the trimmer head counterclockwise. (Fig. 33)
To assemble the loop handle
1. Install the screw into the loop handle. (Fig. 34)
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
Before you operate the product
• Examine the work area to make sure that you know
the type of terrain. Examine the slope of the ground
and if there are obstacles such as stones, branches
and ditches.
• Do an overhaul inspection of the product.
• Do the safety inspections, maintenance and
servicing that are given in this manual.
• Examine the motor for dirt or cracks. Use a brush to
clean the motor from grass and leaves. Use gloves
when it is necessary.
• Examine the trimmer head and cutting attachment
guard for damages or cracks. Replace the trimmer
head and cutting attachment guard if they are hit or if
they have cracks.
• Make sure that all nuts and screws are tight.
• Make sure that all covers, guards, handles and the
cutting equipment are correctly attached and not
damaged before you start the product.
12

Assembly

2. Assemble the loop handle to the attachment on the
shaft.
3. Tighten the screws.
4. Adjust the loop handle to a correct position. Refer to
To adjust the loop handle and telescopic shaft on
page 13 .
To assemble the plant guard
1. Install the plant guard into the holes on the trimmer
head.
2. Make sure that the plant guard can move forward
and rearward freely. (Fig. 35)

Battery information

Refer to the operator's manual of the battery for
information about how to use the battery.

Operation

To connect the battery charger
1. Connect the battery charger to the voltage and
frequency that is specified on the rating plate.
2. Put the plug in a grounded socket outlet. The LED
on the battery charger flashes green one time.
Note: The battery does not charge if the battery
temperature is more than 50 °C/122 °F. If the
temperature is more than 50 °C/122 °F, the battery
charger makes the battery become cool before the
battery charges.
To charge the battery
Note: Charge the battery if it is the first time that you use
it. A new battery is only 30% charged.
1. Connect the battery to the battery charger. (Fig. 36)
2. Make sure that the green charging light on the
battery charger comes on. That means that the
battery is connected correctly to the battery charger.
(Fig. 37)
3. When all LEDs on the battery come on, the battery is
fully charged. (Fig. 38)
4. To disconnect the battery charger from the mains
socket, pull the plug. Do not pull the cable.
5. Disconnect the battery from the battery charger.
782 - 001 - 05.07.2019