Assembly; Operation - Husqvarna 115iHD45 Bedienungsanweisung

Introduction
This section describes how to assemble and adjust the
product.
WARNING: Before you assemble the
product, read the safety chapter and the
assembly instructions.
To connect the battery charger
1. Connect the battery charger to the voltage and
frequency that is specified on the rating plate.
2. Put the plug in a grounded socket outlet. The LED
on the battery charger flashes green one time.
Note: The battery does not charge if the battery
temperature is more than 50 °C/122 °F. If the
temperature is more than 50 °C/122 °F, the battery
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
To charge the battery
Note: Charge the battery if it is the first time that you use
it. A new battery is only 30% charged.
1. Connect the battery to the battery charger. (Fig. 28)
2. Make sure that the green charging light on the
battery charger comes on. That means that the
battery is connected correctly to the battery charger.
(Fig. 29)
3. When all LEDs on the battery come on, the battery is
fully charged. (Fig. 30)
4. To disconnect the battery charger from the mains
socket, pull the plug. Do not pull the cable.
5. Disconnect the battery from the battery charger.
Note: Refer to the battery and battery charger manuals
for more information.
To do before you start the product
1. Examine the work area. Remove objects that can be
thrown out.
2. Examine the cutting attachment. Make sure that the
blades are sharp, and have no cracks and damages.
10

Assembly

charger makes the battery become cool before the
battery charges.
To connect the battery to the product
WARNING: Only use Husqvarna original
batteries in the product.
1. Fully charge the battery.
2. Push the battery into the battery holder of the
product. The battery locks into position when you
hear a click. (Fig. 27)

Operation

3. Make sure that the product works correctly. Examine
that all nuts and screws are tight.
4. Make sure that the handle and safety devices are
not damaged and are attached correctly. Do not
operate a product with missing parts or is changed
from its initial specification. Use protective gloves
when it is necessary.
5. Make sure that the covers are not damaged and are
attached correctly, before you operate the product.
To start the product
1. Press and hold the start/stop button until the green
LED comes on. (Fig. 31)
2. Press the power trigger lockout on the front handle.
(Fig. 32)
3. To apply full power, press the power trigger. (Fig. 33)
To operate the product
1. Start near the ground and move the product up
along the hedge when you cut the sides. Make sure
that the body of the product does not touch the
hedge. (Fig. 34)
2. Hold the product near your body for a stable work
position.
3. Be careful and operate the product slowly.
CAUTION: If the battery does not move
easily into the battery holder, the battery
is not installed correctly. This can cause
damage to the product.
WARNING: Make sure that the front of
the cutting equipment does not touch the
ground.
779 - 001 - 08.07.2019