Assembly - Husqvarna DT600 Bedienungsanweisung

To assemble the attachment
B
A
E
The arrow on the gear housing indicates the direction of
rotation. The gear housing is to be placed as illustrated.
IMPORTANT:
The moss dethatcher rollers are marked with arrows
showing the direction of the rotation. Make sure the
moss dethatcher rollers are fitted correctly.
The moss dethatcher rollers must be fitted slightly
displaced in relation to each other. The moss dethatcher
springs should point in the same direction as the rotation
direction arrow shown on the gear housing.
1. Press the left moss dethatcher (A) onto the left drive
shaft from the gear housing (E).
A
743 - 005 - 07.04.2021
C
B
D
B
C

Assembly

2. Fasten the moss dethatcher roller with split pin (B)
into the inner hole in the shaft.
3. Press the right moss dethatcher (C) onto the right
drive shaft from the gear housing (E).
4. Fasten the moss dethatcher roller with split pin (B)
into the inner hole in the shaft.
5. Mount the splash guard with the snap-on fasteners
(D).
Note:
For assembling accessories on basic product,
refer to the manual of the basic product.
B
C
A
C
E
B
C
A
7