Berner BCLL TOP 183846 Bedienungsanleitung Seite 27

DETECTOR OPERATION (FIG. 9)
1. Set up and position the laser.
2. Turn the detector on by pressing the power button (q).
3. Position the detector so that the sensor window (u) is facing
the laser beam. Move the detector up or down within the
approximate area of the beam, until you have centred the
detector. For information about the display window indicators
and the audible signal indicators, refer to the table titled
Indicators.
Above
Grade
fast beep
4. Use the marking notches (p) to accurately mark the position of
the laser beam.
MOUNTING ON A GRADE ROD (FIG. 9, 10)
1. To secure your detector to a grade rod, fi rst attach the detector
to the clamp by pushing in on the clamp latch (v). Slide the
tracks (w) on the clamp around the rail (x) on the detector until
the latch (y) on the clamp pops into the latch hole (z) on the
detector.
2. Open the jaws of the clamp by turning the clamp knob (a1)
counterclockwise.
INDICATORS
Slightly
Above
Grade On Grade
steady
fast beep
tone
Slightly
Below Below
Grade Grade
slow beep slow beep
ENGLISH
25