Berner BCLL TOP 183846 Bedienungsanleitung Seite 25

ENGLISH
THE LASER BEAMS FLASH (FIG. 2)
The BCLL TOP is designed to self-level up to an average of 4° in
all directions when positioned as shown in fi gure 2. If the laser is
tilted so much that the internal mechanism cannot level itself, it
will fl ash the laser beams – the tilt range has been exceeded. THE
FLASHING BEAMS CREATED BY THE LASER ARE NOT LEVEL
OR PLUMB AND SHOULD NOT BE USED FOR DETERMINING
OR MARKING LEVEL OR PLUMB. Try repositioning the laser on
a more level surface.
THE LASER BEAMS WILL NOT STOP MOVING
The BCLL TOP is a precision instrument. Therefore, if the laser is
not positioned on a stable (and motionless) surface, the laser will
continue to try to fi nd level. If the beam will not stop moving, try
placing the laser on a more stable surface. Also, try to make sure
that the surface is relatively fl at, so that the laser is stable.
Laser Accessories (Optional)
DIGITAL LASER DETECTOR: BCLLD/BCLLD-G (DETECTOR) (FIG. 9)
The Berner Digital Laser Detector (BCLLD/BCLLD-G) helps in
locating a laser beam emitted by the laser in bright light conditions
or over long distances. The detector can be used in both indoor
and outdoor situations where it is diffi cult to see the laser beam.
BCLLD is designed exclusively for use with the BCLL BASIC and
the BCLL TOP line lasers. It is not for use with rotating lasers.
BCLLD-G is designed exclusively for use with the BCLL-G BASIC
and the BCLL-G TOP line lasers. It is not for use with rotating
lasers.
The detector gives both visual signals through the LCD display
window (m) and audio signals through the speaker (n) to indicate
the location of the laser beam.
The Berner Digital Laser Detector can be used with or without the
detector clamp. When used with the clamp, the detector can be
positioned on a grade rod, leveling pole, stud or post.
23