Berner BCLL TOP 183846 Bedienungsanleitung Seite 26

ENGLISH
Batteries (fi g. 9)
The digital laser detector is powered by a 9-volt battery. To install
the battery provided, lift up on the battery compartment cover (o).
Place the 9-volt battery in the compartment, aligning the battery as
shown on the embossed icon.
Detector Controls (fi g. 9)
The detector is controlled by the power button (q) and the volume
button (r).
When the power button is pushed once, the detector is turned on.
The top of the sensor window shows the ON icon and the volume
icon.
The Berner Digital Laser Detector also has an auto shut-off feature.
If a laser beam does not strike the beam detection window, or if
no buttons are pressed, the detector will shut itself off in about
5 minutes.
To turn off the audible signal push the button again; the volume
icon will disappear.
The detector powers up in the narrow accuracy setting (icon
appears in the lower left corner). Press the accuracy button (s)
once to change to wide accuracy setting (icon now appears in the
lower right corner).
Accuracy
The detector provides two accuracy settings, wide and narrow.
In the wide setting, the detector provides a larger tolerance for
indicating that the detector is "on grade". In the narrow setting, this
tolerance is reduced for more accurate indication of "on grade".
For the most accurate results, start the work using the wide setting
and fi nish in the narrow setting.
Magnets
The magnets (t) allow the detector to be mounted to the metal
tracks during the installation of a suspended ceiling.
24