Data Configuration; Error Detection - Citizen CBM-270 Bedienungsanleitung

7.3.2

Data Configuration

Mark
Space
(1) Start bit
The system reads the status again after a lapse of 1/2 bit from a fall edge from the mark to space, and if it
is a space, this bit will be recognized as the start bit.
If it is a mark, the system will not recognize the bit as the start bit and try to detect the start bit again
without judging it as an error.
(2) Data bits + Parity bit
The system samples the data bits and parity bit for the 1 bit worth of time from 1/2 start bit and assumes
the then status as the data for the relevant bits.
from the one closest to the start bit.
(3) Stop bit
The stop bit is the Mark level of 1 bit or more.
error will result.
7.3.3

Error Detection

The system detects a parity, framing, or overrun error.
stored in the buffer as "?".
(1) Parity error
With a parity check specified, if an error is detected at parity check time, the relevant data will be
stored in the buffer as "?".
(2) Framing error
This error results if the Space status is detected at stop bit detection time.
stored in the buffer as "?".
(3) Overrun error
If an overrun error is detected, the relevant data will be stored in the buffer as "?".
, • • • •
b , b , b
0 1 2
(1)
(1) Start Bit
(2) Data Bit (+ Parity Bit)
(3) Stop Bit (1 or More)
(2) (3)
The bits are called Bit 0, Bit 1, ..., Parity bit, counting
If a space is detected in detecting the stop bit, a framing
If an error is detected, the relevant data will be
25
CBM-270 User's Manual
t
The relevant data will be
CITIZEN