Preparation By The User; Space Requirements - Bosch VLH 2140 Erstinbetriebnahme

en 26 | VLH 2140 | Symbols used
2.4

Preparation by the user

2.4.1

Space requirements

Fig. 3: Recommended work station dimensions
4.5 m
(arrow = direction of travel)
A safety clearance of at least 1 meter must be main-
tained in front of and behind the vehicle as well as to
the sides of the lifting platform. There must be suffi-
cient space at the ends of the lifting platform for driv-
ing vehicles on and off.
Ceiling height: At least 0.1 m higher than the total
height of the lifting platform. For increasing height
of lifting platform:
3.77 m / 4.1 m / 4.3 m / 4.5 m / 4.75 m.
|
1 689 978 569 2017-08-02
2.4.2 Construction of foundation
¶
Construction of the foundation following consultation
with Bosch customer service or an authorized service
agent.
Dimensions:
Version
Continuous footing
Individual footing
Grade of concrete:
Specifications
Type
Concrete quality B 4710-1
Surface
Reinforcement, top and bottom
i
Refer to Section 7 for foundation plans.
!
The base plates of the lifting platform must be posi-
tioned as per the foundation plan.
Ground:
R
The ground must comply with the general guidelines
for foundations (Eurocode 7, formerly DIN 1054).
R
In the case of outdoor installation, the ground must
be frost-proof.
!
The lift may not be installed outdoors. At least one
weather-proof enclosure is required.
!
If the lifting platform is anchored to an existing rein-
forced concrete floor, individual verification must be
provided by a structural engineer or building expert!
!
Prior to installation, the condition of the concrete and
ground must be checked by means of trial drilling.
Length x width
1200 mm x 3535 mm
Concrete thickness min.
210 mm
1200 mm x 800 mm (2x)
Concrete thickness min.
500 mm
Designation, value
Uncracked concrete
C 20/25
Horizontal and flat
(slope max. 0.5 %)
BSt 500 M, Q131
Robert Bosch GmbH