Operation; Receiving The Dcf Radio Time Signal; Setting The Time Manually - Auriol Z30300 A Handbuch

©
©
The wall clock automatically starts to search for the DCF radio time signal.
This process takes about 3-10 minutes to complete.
The reception of the DCF radio time signal by the wall clock can also
be started manually.
Note: If the wall clock was not able to receive the DCF radio time
signal because of errors, e.g. due your location to being at too great a
distance from the transmitter or for other reasons, you can set the time
manually. The manually set value is overwritten as soon as reception
of the DCF radio time signal is successful.
HINTS: Press the button by using a pointed object (e.g. pencil).
©
53674_aur_Wanduhr_content_LB7.indd 9

Operation

Receiving the DCF radio time signal

Press and keep pressed the 5 0 button
wall clock attempts to receive the DCF radio time signal. This process
takes a few minutes to complete.

Setting the time manually

Press and keep pressed the SET button
The wall clock switches into manual mode.
Press and keep pressed the SET button
reach the correct position for you to set the time.
Briefly pressing the SET button
one minute steps to enable you to set the current time manually.
Note: After 7 seconds without pressing the SET
wall clock switches out of manual mode and keeps the time as
at least 5 seconds. The
2
at least h seconds.
5
again until the hands
5
moves the hands forward in
5
5
button, the
GB/CY 9
08.07.10 09:54