Adjustments; Adjusting The Clutch Cable; Adjusting The Main And Parking Brake; Adjusting The Accelerator Cables - GOLDONI EURO series Bedienung Und Instandhaltung

Stop filling when the water spills from the valve: the tyre contains about 40 liters
of water. Tighten the mobile element back on the valve, lock the ring nut and
inflate the tyre as indicated.
The water is drained out in the same way but by moving the valve to the bottom.
Warning: Only ballast the tractor if necessary and in the described way. Use
antifreeze solutions in cold climates.

5.7 ADJUSTMENTS

The following instructions concern the main adjustments that must be made.
These adjustments are very simple. Contact one of our Assistance Centers if
you experience any difficulties.

5.7.1 Adjusting the clutch cable

When the free travel of the pedal is less than 10 mm, it must be regulated by
means of adjuster n.1 fig.21 mod.30SN-30A-40SN-40A, n.1 fig.27 mod.W40RS-
40R-W45RS-45R-45RS.

5.7.2 Adjusting the main and parking brake

Lengthen rod 1 fig. 12 if one of the two rear wheels brakes differently to the
other or if there are differences in the free travel of the main brakes (N° 3 fig. 1)
or emergency – parking brake lever (N° 6 fig. 1).
This adjustment should be carried out separately on both wheels.
For mod. 30SN-30A, loosen nut N°2 fig.24 and operate on sleeve N° 1 fig.24,
then lock in place with nut N°2 fig.24.

5.7.3 Adjusting the accelerator cables

To adjust the travel of the hand lever, use the adjuster screw behind the lever
itself.
The accelerator pedal cables are adjuster by means of the adjuster screws on
the engine end of the cables themselves.

5.7.4 Adjusting the motor stop cable

Use the adjuster screw on the engine end of the cable if the travel of the motor
stop knob is excessive.

5.7.5 Adjusting the front wheel toe-in (Mod. RS-R)

The front wheel toe-in is correct when it complies with the measurements in fig.
14.
103