Canon imageRunner C1028iF Handbuch Für Starter Seite 24

2 Set Up the Machine
5
Press the right Any key to select <Done>.
Changes to the IP address, subnet mask, and gateway
address settings will be efective after restarting the
machine.
6
Use [ ▼ ], [ ▲ ] or (Scroll Wheel) to select
<TCP/IP Settings>, then press [OK].
7
Use [ ▼ ], [ ▲ ] or (Scroll Wheel) to select
<IPv4 Settings>, then press [OK].
For instructions on the settings for IPv6, see "Network
Settings, " in the e-Manual.
22
8
Use [ ▼ ], [ ▲ ] or (Scroll Wheel) to select <IP
Address Settings>, then press [OK].
9
Press the left Any key to select <Conirm Set.>.
10
Press the right Any key to select <Done>.
–
If the machine is communicating with the network
properly, the IP address, subnet mask, and gateway
address are displayed. If not, "000.000.000.000" is displayed.
–
If the machine dose not obtain the IP address 3 minutes
after you connected the LAN cable, check the IP address
settings and the network cable.
11
Press (Main Menu) to return to the
Main Menu screen.