Siemens FUT1010 IP65 NEMA 4X Betriebsanleitung Seite 14

Introduction
1.3 Pressure Equipment Safety Notes
Sensor Failure
Sensors have been designed to account for loads to internal pressures in accordance with
ASME codes. If ignored the potential for injury exists.
It is the responsibility of the user to access and account for other externally applied loads
due to earthquakes, pipe movement and other environmental conditions.
Equipment Instability
If incorrect installation equipment is used when installaing vertical sensor configuations, the
potential for injury exists.
During vertical Sensor installation use appropriate equipment to ensure safety.
Flange Failure
Incorrect selection of bolting and gasket materials which will fall within the limits of the
flange and its intended use and which are suitable for the service conditions create the
potential for injury.
The user is responsible for the correct selection of bolting and gasket materials which will
fall within the limits of the flange and its intended use and which are suitable for the service
conditions.
Pressure Hazard
If repair to the instrument is attempted when it is under pressure, the potential for injury
exists.
Never attempt to loosen, remove, or disassemble process connection or instrument
housing while contents are under pressure. Restrict use and repair to qualified personnel.
Sensor Failure
if condensation is not removed from the Sensor before it is installed in the line, the potential
for injury exists.
Remove all condensation from Sensor before installing into line.
12
WARNING
WARNING
WARNING
WARNING
WARNING
FUT1010 IP65 NEMA 4X & IP66 NEMA 7 Gas Quick Start
Operating Instructions, 1/2013, A5E02639183-AC