Disable Of Room Sensor On Dd2; Installation Manual; Place Of Mount - OEG DD2+ Handbuch

Disable of room sensor on DD2+

Room unit has built in function to disable room sensor influence for
5 hours. To activate this function, hold key ECO for 15 seconds
(Parameter S1.4 needs to be set to value 5!).
This function is especially useful in cases of heating with fireplace
or other heat source, which is operating independently to controlled
heating system.

Place of mount

Place of mount is very important for proper DD2+ operation. Suita-
ble places are inner walls, which aren't sun lighted or exposed to
sources of heat and wind. DD2+ should be mounted approximately
150 cm above the floor (Picture 17).
Picture 17

INSTALLATION MANUAL

22