OEG DD2+ Handbuch Seite 18

Basic parameters P1
Basic parameters P1 are used for the thermostat user settings. To change the
selected parameter, hold key
starts to flash. Press key
setted value, again hold key
contains the following parameters; (factory setting):
- [P1.1] night temperature (6 °C ÷ 26 °C); (17 °C)
- [P1.2] temperature reduction in ECO mode
(0 °C ÷ -9 °C); (-3 °C)
- [P1.3] frost protection temperature (0 °C ÷ 20 °C); (6 °C)
- [P1.4] temperature sensor calibration (-2 °C ÷ 2 °C); (0 °C)
- [P1.5] auxiliary temperature sensor calibration
(-2 °C ÷ 2 °C); (0 °C)
- [P1.6] display of measured temperatures (1 - room, 2 - outdoor,
3 - room and outdoor alternating, 4 - requested temp.); (1)
- [P1.7] beeper mode (- - - silent, 1 - by typing, 2 - by timer
switchover, 3 - by typing and timer switchover); (1)
- [P1.8] display of controlled devices (1 - visible, 2 - hidden); (1)
- [P1.9] temperature increase in PARTY mode
(0 °C ÷ -9 °C); (0 °C)
- [P1.10] temperature display by ESC command in normal display (see table):
Parameter WHMS
value
P1.10 = --- Auxilliary sensor DD2+
P1.10 = 1 Room temperature
P1.10 = 2 Not used.
P1.10 = 3 Outdoor temperature
P1.10 = 4 Stand-pipe
SETTING MANUAL
for approximately 5 seconds. Parameter
or to set the parameter value. To store the
for approximately 5 seconds. Group P1
KMS
Auxilliary sensor DD2+
Outdoor temperature AF
Room temperature RF
Stand-pipe VF
Return-pipe RLF
18