FLAEM Air Pro 3000 Plus Version series Bedienungsanleitung Seite 15

PRESSURE ADJUSTMENT
6.a Operating pressure
After connecting nebuliser RF7 Plus to the device with the Selector Button (C1.4) closed in the position With Valve, op-
erating pressure can be adjusted by rotating Knob (A3), clockwise to increase it or anti-clockwise to decrease it, until se-
lecting the colour sector visible on the Pressure Gauge (A6) matching the desired particle size shown in the table below.
Throughout the device life, from time to time it is necessary to check maximum pressure attainable with the RF7 Plus
nebuliser connected and with Knob (A3) turned on MAX.
If the maximum value of the green sector in the Pressure Gauge is not reached (A6), the device must be serviced.
CHOICE OF DELIVERY METHOD
6.b Delivery method
Nebulisation can be obtained by maintaining the valve system active, or selecting the delivery mode at top speed, by
means of the Selector Button (C1.4) of RF7 Plus atomiser. The mode must be selected after setting the operating pressure.
7. Start the device by means of switch (A1) and breathe deeply in and out.
8. Upon completing application, turn off the device and unplug it.
9. If after the therapy session an evident deposit of moisture forms within the pipe (B), detach the pipe from the nebuliser
and dry it with the very ventilation from the compressor; this operation prevents possible blooms of mould inside the
pipe.
RF7 PLUS TECHNICAL NEBULISATION FEATURES
Pressure gauge value bar
Nozzle flow (1) l/min'
Selector Button Position
MMAD μm (2)
(2) Breathable fraction< 5 μm (2)
Delivery ml/min' (1) approx
(1) Data recorded according to in-
ternal Flaem procedure I29-P07.5.
Delivery Speed values are subject
to variations depending on the pa-
tient's respiratory ability.
(2) In vitro characterization certi-
fied by TÜV Rheinland LGA Products
GmbH - Germany in compliance with
European Standard for Aerosol ther-
apy apparatuses EN 13544-1. Further
details are available on demand.
2
30
1
20
40
EN 837-1
10 50
psi
60
0
bar
0
Kl. 2,5
Green Area Yellow Area Orange Area
1,15 ÷ 1,45 0.90 ÷ 1.15
8.2 7.1
with Valve with Valve
2.21 2.76
84.2% 78.5%
0.29 0.23
WITH VALVE
13
3
4
Green Area
0.70 ÷ 0.90 1.15 ÷ 1.45
6.8 8.2
with Valve MAX
2.95 2.38
74.7% 81.5%
0.18 0.65
Yellow Area Orange Area
0.90 ÷ 1.15 0.70 ÷ 0.90
7.1 6.8
MAX MAX
2.91 2.44
76.0% 80.7%
0.53 0.42
MAX