Operation; Cleaning And Maintenance; Technical Specifications - EuroLite LED ML-20 Bedienungsanleitung

The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.

OPERATION

After connecting the spot to the mains, the EUROLITE LED ML-20 starts running.

CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by authorized dealers only
in order to avoid hazards.
Should you have further questions, please contact your dealer.

TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
Dimensions (LxWxH):
Weight:
Maximum ambient temperature T
Maximum housing temperature T
Minimum distance:
Number/LEDs:
LED beam angle:
Please note: Every information is subject to change without prior notice. 02.03.2007 ©
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
230 V AC, 50 Hz ~
4 W
125 x 105 x 120 mm
0.5 kg
: 45° C
a
: 55° C
B
0,10 m
3
25°
13/23 51914800_V_1_0.DOC