Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DESCRIPTION
3x1 W LED Spot with Design Multi Lens Spot housing
• High-power LEDs (1 Watt)
• Illumination angle approximately 25°
• Locking possibility at the mounting bracket
• For illuminating e. g. mirror balls, entrance or counter areas or as basic illumination
• Effect lighting in public places, main halls, stages, lounges and exibitions
• Advantages of high-power LED-technology: extreme light output, extremely long life, low power
consumption, defacto maintenance free
• Ready for connection with 1m power cord and safety-plug
• Available in 5 colors and 2 color temperatures (white)
• Available in silver, black, or white housing
INSTALLATION
Before attaching the device, make sure that the installation area can hold a minimum point load of 10 times
the device's weight.
The device must only be installed absolutely planar at a vibration-free, oscillation-free and fire-resistant
location. Make sure that the device is installed absolutely planar by using a water-level.
The device must be installed out of the reach of people.
The device must always be installed via all fixation holes. Do only use appropriate screws and make sure
that the screws are properly connected with the ground.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
Procedure:
Step 1: The hole for the installation is on the mounting-bracket.
Step 2: Hold the mounting-bracket onto the location where the device is to be installed.
Step 3: Mark the borehole with a pen or a suitable tool.
Step 4: Drill the hole.
Step 5: Hold the mounting-bracket in the desired position and tighten it.
Before taking into operation for the first time, the installation has to be approved by an expert!
Connection with the mains
Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
DANGER TO LIFE!
International
L
N
12/23
51914800_V_1_0.DOC
Werbung
Inhaltsverzeichnis
