Rc 100 Remote Control; Rc 200 Remote Control; Mig/Mag Series Torches; Push-Pull Series Torches - voestalpine WF 330 ArcDrive Smart Gebrauchsanweisung

4.2 RC 100 remote control

The RC 100 is a remote control unit designed to manage the
display and the adjustment of the welding current and voltage.
"Consult the instruction manual".
4.3 RC 180 remote control
This remote control unit makes it possible to change the output
current without interrupting the welding process.
"Consult the instruction manual".

4.4 RC 200 remote control

The RC 200 is a remote control unit designed to manage the
display and the adjustment of all available parameters of the
power source to which it is connected.
"Consult the instruction manual".

4.5 MIG/MAG series torches

1 Torch button
"Consult the instruction manual".

4.6 Push-Pull series torches

1 Torch button
"Consult the instruction manual".
4.7 RC kit (WF...RapiDeep Steel) (73.11.015)
"Consult the "Installation kit/accessories" section".

4.8 Push-Pull kit (73.11.012)

"Consult the "Installation kit/accessories" section".

4.9 Feed unit wheels - upgrade kit (73.10.073)

"Consult the "Installation kit/accessories" section".

4.10 Feed unit wheels - upgrade kit (73.10.074)

"Consult the "Installation kit/accessories" section".

5 MAINTENANCE

Routine maintenance must be carried out on the
system according to the manufacturer's instruc-
tions.
Any maintenance operation must be performed by qualified
personnel only.
When the equipment is working, all the access and operating
doors and covers must be closed and locked.
Unauthorized changes to the system are strictly forbidden.
Prevent conductive dust from accumulating near the louvers
and over them.
Disconnect the power supply before every opera-
tion!
Carry out the following periodic checks on the
power source:
- Clean the power source inside by means of low-
pressure compressed air and soft bristle brushes.
- Check the electric connections and all the con-
nection cables.
For the maintenance or replacement of torch components,
electrode holders and/or earth cables:
Check the temperature of the component and
make sure that they are not overheated.
39