Changing The Access Level; Locking The Unit, Changing A Password; Showing System Information - IMG STAGE LINE DSP-26 Bedienungsanleitung

5.4.4 Changing the access level

To change the access level and thus to obtain other access rights
☞
( chapter 5 .1), enter the appropriate password:
1) Enter the menu item
Access Level:
2) Use the rotary knob SELECT/ ENTER (3) to select the option
, then press the knob .
Unlocked
will appear on the display .
Enter Password
3) Enter the password required:
– Use the rotary knob SELECT/ ENTER to select a character (upper-
case letter, lowercase letter, digit or special character) .
– Press the rotary knob to go to the next character .
– Use the button EXIT to go to the previous character position .
To delete the entire entry, go to the first character position and
press the button EXIT .
– Use the button MENU to confirm the final character of the pass-
word and to terminate the entry .
Note: To overwrite characters you may have accidentally entered at the end
of the password, use the blank character . It can be found after the
lowercase letters, following the character "}" .
When an incorrect password is entered, the following message will
appear on the display:
Access Level:
**** Locked ****
In this case, repeat steps 2 and 3, using the correct password .

5.4.5 Locking the unit, changing a password

With the steps described below, the unit will be set to the lowest
access level (Locked State) . In addition, it is possible to change the
password for the access level "User" .
1) Call up the menu item
Access Level:
2) Use the rotary knob
, then press the knob .
**** Locked ****
will appear on the display .
3) Enter either the current password for the access level "User" or a
new password:
– Use the rotary knob SELECT/ENTER to select a character (upper-
case letter, lowercase letter, digit or special character) .
– Press the rotary knob to go to the next character .
– Use the button EXIT to go to the previous character position .
To delete the entire entry, go to the first character position and
press the button EXIT .
– Use the button MENU to confirm the final character of the pass-
word and to terminate the entry . Make sure to remember a new
password!
Note: The maximum length of the password is 8 characters . To overwrite
characters you may have accidentally entered at the end of the pass-
word, use the blank character . It can be found after the lowercase
letters, following the character "}" .
4) will appear on the display . To confirm the
Confirm Password
password, press the button MENU again, or, to change the pass-
word again, press the button EXIT .
The unit is now locked (Locked State) . It can only be unlocked when
a correct password is entered (
.
.
SELECT/ ENTER (3) to
Set Password
☞
chapter 5 .4 .4) .

5.4.6 Showing system information

1) Call up the menu item
2) Use the rotary knob SELECT/ ENTER (3) to select the information
to be shown:
= serial number
SN
= firmware version
FW
= hardware version
HW
select
.
Version Info
27