Checking The Charge Status Of The Rechargeable Battery; Recharging The Battery; Control Display On Charger - Parkside PLSA 40-Li A1 Originalbetriebsanleitung

• Charge the battery before the first time
of use.
• To recharge the battery, only use a
charger belonging to the Parkside
X 20 V TEAM series.
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to be
replaced. Only use an original replace-
ment battery from the Parkside X 20 V
Team series, which can be purchased
from customer service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information.
• The warranty excludes all defects
caused by improper handling.
Checking the charge status
of the rechargeable battery
The battery charge status indicator (3)
signalises the state of charge of the battery
(4).
Press the button (2) on the battery. The
state of charge of the battery is displayed
by illuminating the 3-colour LED lights of
the state of charge display.
3 LEDs light up (red, orange and green):
Battery is fully charged.
2 LEDs light up (red and orange):
Battery has a residual charge.
1 LED lights up (red):
Battery has to be charged
Only charge the battery (4) when
the red LED on the charge status
indicator (3) is on.

Recharging the battery

Allow a hot battery to cool before
charging.
Only charge the battery (4) when
the red LED on the charge status
indicator is on.
The charging time with the dual
charger is about 1 hour.
1. Remove the battery (4) from the appli-
ance, as necessary (see „Removing/
inserting the battery").
2. Insert the battery (4) in the charging
compartment of the battery charger
(5).
3. Plug the battery charger (5) into a
mains outlet.
4. When the battery is fully recharged
unplug the battery charger (5) from the
mains.
5. Remove the battery (4) from the charg-
er (5).

Control display on charger

The direction in which to read the
control display (6) is from the bot-
tom up.If the charger is connected
to the mains socket and no battery
is inserted, all LEDs will light up per-
manently.
An LED flashes:
Batter(ies) (4) empty
An LED lights up, a second LED flashes:
Batter(ies) charged to 1/3
Two LEDs light up, third LED flashes:
Batter(ies) charged to 2/3
GB IE NI
9