Initial Start-Up; Charging The Battery; Remove/Insert Battery - Parkside PLSA 40-Li A1 Originalbetriebsanleitung

Initial start-up

Before operating the device, you must
- insert the batteries,
- install the blower or suction pipes,
- install the collection bag for suctioning
leaves,
- insert the protective cover for leaf
blowing.
The cordless leaf vacuum/blower
has a safety contact, which is lo-
cated in the motor housing (
where the protective cover (
or the suction pipe (
If these contacts are
ted.
not activated, the device
cannot be started!
Pay attention to the correct assembly
- protective cover (7) for blowing
mode;
- suction pipe (16) for vacuum
mode.
Caution! Risk of injury!
During the assembly or di-
sassembly of the blowpipe,
suction pipe, protective cover
or collection bag, the device
must be turned off and all
moving parts must have
come to a standstill. Remove
the batteries before carrying
out any work!

Charging the battery

Ensure that the ambient tem-
perature does not exceed
50°C or fall below 0°C during
the charging process.
If warm, allow the battery to cool
before charging.
1. Remove the battery (5) from the device.
2. Plug the charger (6) into a socket.
3. Slide the battery (5) onto the charger
4. Remove the battery (5) from the char-
5. Once charging is complete, disconnect
1),
7)

Remove/insert battery

16) is moun-
1. To remove the battery (5) from the de-
2. To insert the battery (5), push the bat-
1. Assemble the three-piece blowpipe (9)
Do not expose the battery to direct
sunlight for long periods and do
not place it on a radiator (max.
50°C).
(6) up to the stop.
ger (6).
the charger (6) from the mains supply.
vice, press the release button (5a) on
the battery (5) and pull the battery out.
tery (5) along the guide rail into the
device. You will hear it click into place.
Only insert the battery once
the battery-operated tool is
fully ready for use.
Assembling/
dismantling the three-
piece blowpipe
Never use the leaf blower
with only one blowpipe sec-
tion attached. There is a risk
of personal injury!
Pay attention to the correct as-
sembly of the protective cover (7),
otherwise the leaf blower will not
start.
as illustrated. The parts can be felt to
lock into place.
GB IE NI
13