E&P HYDRAULICS V6A Bedienungsanleitung Seite 60

Special features/Tips
• After 4 minutes of no operation, the system will switch off automatically.
• T he automatic levelling cycle can only be started after all jacks have been retracted.
If the jacks are not retracted when the automatic cycle starts, the system will do this
automatically. So it is not possible to make short adjustments to the jacks; the system
will always first completely retract its jacks.
• At a low battery voltage, the system will automatically switch off completely.
• J acks are extended and you want to drive: the system will immediately give an alarm
and the jacks are automatically retracted as soon as the hand brake is being disenga-
ged. In case of vehicles with a pneumatic brake installation, this takes place when the
engine is started.
• All normal functions of the system are switched off in error mode.
• A lways operate the cylinders 2 at a time at 1 side; when retracting, operate all 4 at
the same time. Only in case of short adjustments afterwards, briefly operate all 4
cylinders separately.
• S wivel chairs: some campers have swivel chairs that do not function when the hand
brake is engaged. As soon as the levelling system is finished and the ignition contact
of the car is off, you are able to disengage the hand brake. Before doing that, you
must of course check if the car is in gear.
• D uring winter sports: put something (e.g. a piece of carpet) under the jacks to avoid
sliding.
• Manual operation is mainly recommended for bad surfaces.
• In manual operation, all jacks should always be extended.
• The system cannot handle all angles, the limit values differ per camper.
• I f the system makes a slope angle that is too big and no longer responds to requests
for automatic levelling, we recommend bringing the camper as close as possible to
the zero point in manual mode.
• Y ou will notice that the system also has a semi-automatic function. During manual
operation, 1 or 2 arrows can light near the green LED 14. In this way, the system
indicates where the lowest points are at that moment. Example: first extend the rear
jacks by manual operation (camper is moving). Wait a moment, then press the arrow
for the front jacks. It will stop automatically when the zero point is reached.
• A nother option in case of a slope angle that is too high, is to drive the camper on
wedges and to fill up the jacks (please do take the stability into account).
60