Control Panel - E&P HYDRAULICS V6A Bedienungsanleitung

Control Panel

(1) LED message SLOPE TOO STRONG – In this position the camper cannot
be levelled (the surface is not even enough). If necessary, switch over to
manual mode.
(2) LED message LOW VOLTAGE – the battery is empty or the voltage is
too low to be able to work safely.
(3) LED message ENGAGE HAND BRAKE – Message indicating that the hand
brake is disengaged. When the hand brake is engaged again, the LED will go out.
(4) LED message JACKS NOT (fully) RETRACTED –
One or more jacks are extended or not fully retracted.
(5) Button ON/OFF – switches the control panel on or off.
(6) Button MANUAL MODE – the switch panel is in manual mode.
(7) button AUTOMATIC MODE ON – indicates that the system is ready for
automatic levelling of the camper.
(8) Button RETRACT ALL JACKS – automatically retracts all jacks.
(9) LED message MANUAL MODE – indicates that the camper can now
be brought to the correct level manually.
(10) Button LEFT SIDE – controls retracting and extending the left jacks.
(11) Button REAR SIDE – controls retracting and extending the rear jacks.
(12) Button FRONT SIDE – controls retracting and extending the front jacks.
(13) Button RIGHT SIDE – controls retracting and extending the right jacks.
(14) LED message LEVEL – indicates that the camper is brought to the required level.
14
57