Retracting The Jacks; Wiring (Diagram) - E&P HYDRAULICS V6A Bedienungsanleitung

Retracting the jacks

Tip: if, halfway through the procedure, you want to cancel the retraction immediately,
switch the system off (button no. 5) and on again (also by means of button no. 5).
1. Switch on the system (button no. 5). The message ON/OFF lights.
2. Press the button RETRACT ALL JACKS (no. 8). If in manual mode, the jacks are
only retracted as long as the button RETRACT is pressed. In automatic mode, you
only have to press button RETRACT once. When all jacks have been fully retracted,
the LED JACKS DOWN (no. 4) will go out.
3. Switch off the system by means of the ON/OFF switch (no. 5) on the switch panel.
After a short inspection around the camper, to check if the jacks are fully retracted,
you can drive off.
Wiring:
14
Cable plug with 9 pens:
1. Brown (ground)
2. Dark red (valve front right)
3. Grey (pump extend)
4. Green (valve front left)
5. Yellow (float switch)
ground-black
6. Blue (valve rear left)
7. White (drive undercarriage)
8. Black (pump retract)
9. Red (valve rear right)
manual reset
breaker
59