Settings; Setting The Zero Point - E&P HYDRAULICS V6A Bedienungsanleitung

Settings

Setting the zero point:

Before automatic levelling can be activated, you must set the zero point. This is the point
to which the system returns in an automatic cycle.
For setting the zero point, you must first perform a manual levelling, so that the vehicle
can be placed on the required level. Only then, you will be able to set the zero point. Do
this by placing a spirit level in the car For activating this mode, you must follow the next
sequence:
Switch off the control panel. Switch on the control panel.

Press the button FRONT (no. 12) five times.

Press the button REAR (no. 11) five times.

All LEDs will be flashing.

You are now in the zero mode.

Press button RETRACT ALL (no. 8) three times while in zero mode, in order to set the
zero point. Wait 20 seconds, until the system has saved the zero point.
56