Using The Heater; Safety System - RUSTA 906512360101 Gebrauchsanweisung

USING THE HEATER

Note: Powering off the heater will stop the heating process only. The fan will continue to blow
for approximately 1 minute to allow for the interior components to cool. The fan will then turn
off automatically.
1. Plug the heater into a suitable power outlet, observing all the instruction regarding
positioning. The distance between the heater bottom and the ground should be more than
10cm, the distance between the side of the heater and the wall or any other object should
be more than 50cm.
2. Press " " on side of the unit to "I" position to turn on the heater.
3. Press " " button, the heater will start automatically.
4. The "Temp. +" button is for increasing the temperature setting in High or Low mode.
5. The "Temp. -" button is for decreasing the temperature setting in High or Low mode.
6. The "Speed"-function ("Temp. +" and "Temp. -" buttons together) is for selecting the fan
speed setting in High or Low mode.
7. Press "Timer" to set timer (0–12 hr).
POWER-OFF TIMER
When the heater is running, press "Timer", the digital display changes from the
"temperature" to the "hours" option for the timer. Continue to press the timer button to
change the number of hours you would like the heater to run before powering itself off.
The hour options for the timer are from 0 to 12 hrs. (In 1 hour increment).
POWER-ON TIMER
When the heater is off, Press "Timer", the digital display shows the "hours" option for the
timer. Continue to press the timer button to change the number of hours you would like the
heater's internal clock to count down before powering itself on. The hour options for the
timer are from 0 to 12 hrs. (In 1 hour increment).
8. When finished, Press " " button, the heater will be off automatically in 1 minute, switch
the power switch at the side of the heater to "0" position and unplug heater from power
outlet.

SAFETY SYSTEM

• In the event of abnormal overheating, a safety device shuts the appliance off automatically.
After a short cooling down phase, the appliance is ready for use again.
• If the same defect keeps recurring, remove the device from the socket and consult your
authorized dealer or your after-sales service department.
• During use, do not touch or cover the air outlet. This may cause the unit to overheat, and
the safety device to operate.
7