Operation; Cleaning The Heater - RUSTA 90651092 Gebrauchsanweisung

ENG
ASSEMBLY OF THE HEATER
Before using the heater, the feet (supplied separately in the carton), must
be fitted to the unit. These are to be attached to the base of the heater
using the 4 self-tapping screws provided, taking care to ensure that they
are located correctly in the bottom ends of the heater side moldings.

OPERATION

PLEASE NOTE! It is normal when the heaters are turned on
for the first time or when they are turned on after having not
been used for a long period of time the heaters may emit
some smell and fumes. This will disappear when the heater
has been on a short while.
CONVECTOR HEATER WITH THERMOSTAT DL15 STAND
• Choose a suitable location for the heater, taking into
account the safety instructions above.
• Insert the plug of the heater into a suitable socket.
• Turn the thermostat knob fully in a clockwise direction to the maximum setting.
• Turn on the heating elements by means of the rocker switches on the side panel.
When the heating elements are on the switches will illuminate. For maximum heat
output both switches should be on.
• When the desired room temperature has been reached, the thermostat knob should be
turned slowly anti-clockwise until the thermostat is heard to click off and the lights on
the element switches are seen to go out.
• After this the heater will keep the air temperature in the room at the set temperature
by switching on and off automatically.

CLEANING THE HEATER

• Always un-plug the heater from the wall socket and allow it to cool down before
cleaning.
• Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth.
• Do not use any detergents or abrasives and do not allow any water to enter the heater.
STORING THE HEATER
When the heater is not used for long periods of time it should be protected from dust and
stored in a clean dry place.
4
Rocker
switches
Thermostate
knob