Otto Bock 1C60 Triton Gebrauchsanweisung Seite 14

2C6=*N Normal Footshell
2C6=(Side)(Size) / (Colour)N
Order example: 2C6=L27/4N
Sides
Sizes (cm)
Colours
3.4 Single Component Pack (see Fig. 1)
2F60 Triton Heel Wedge Kit
Order example: 2F60=24–25
Sizes (cm)
4 Assembly
4.1 Setup
4.1.1 Footshell application / removal
NOTICE
Risk of damage as a result of improper use.
The foot is designed to be used with the footshell. Please avoid frequent removal from and in-
sertion into the footshell as this can damage the carbon fibre elements.
NOTICE
Risk of damage as a result of improper footshell assembly.
Do not use a screwdriver for assembly and disassembly as this can cause damage to the
carbon elements and/or footshell. Otto Bock recommends use of 2C100 Footshell Insertion/
Removal tool (accessories).
NOTICE
Risk of damage as a result of improper use.
The footshell must not be dusted with talcum powder as this would increase abrasion. Use sili-
cone spray for lubrication if needed. Replace the footshell in case it shows any damage or wear.
Inserting the foot into the footshell:
• Attach the tube adapter to the prosthetic foot. This helps, makes it easier to insert the foot into
the footshell.
• Insert the foot into the footshell.
• Make sure the heel of the polymer base spring securely snaps into the footshell heel tab.
Removing the footshell:
• Insert the 2C100 Footshell Insertion/Removal tool under the heel of the polymer base spring
which is located under the heel tabs in the posterior part of the footshell
• Pry the heel out of the shell and pull the foot out of the footshell.
14
– – –
21 – 22 23 – 24
left (L), right (R)
24 25 26
beige (4), light brown (15)
25 – 26
27 28 29
27 – 28 29 – 30
30